Process debugging

For process debugging go to Debug mode and switch its status to Debugged

Debug tools

  • + New task - adding parameters and launch of test task
  • Add breakpoint - addition "breakpoint" during debugging
  • Add start point - addition debugging start point добавление точки старта отладки
  • Controls for debugging mode - Repeat, Start/Stop, Step back, Step forward

New task

In order to add parameters and send test task:

  • press + New task
  • press + Add "key-value"
  • add required parameters
  • in case of need, specify task refrence in Reference field
  • press Add task

Using controls of debugging process management you can manage it: step by step moving through process, repeat debugging, start debugging.

Task parameters can be edited directly in debugging process.

Breakpoint -

It is the point where debugging mode will be paused.

In order to add breakpoint, take it from pannel and put it on the right place.

In order to remove breakpoint, select it and press Delete button on your device's keybord.

Start point -

this is new debugging start point.

Start point can be added only in one instance.

In order to add Start point, take it from pannel and put it on the right place.

In order to delete Start point, select it and press Delete button on your device's keybord.

Debugging with Delay

If there are additional conditions in logic (Delay logic), then you will have to choose a path for next task in the appropriate stage of debugging.

results matching ""

    No results matching ""

    Would you recommend to your colleagues Corezoid.com documentation for learning?
    Please enter your email to feedback
    Thank you!